Administrators Dazz Posted March 3, 2013 Administrators Share Posted March 3, 2013 Anyone see any glaring mistakes other than my horrible soldering job? Diode install on Knocker This is the first time I've ever soldered anything like this so not sure if it looks right or not. I checked for continuity on each input and the +. So far everything checks out ok. Resistor board Link to comment Share on other sites More sharing options...
maxxsinner Posted March 4, 2013 Share Posted March 4, 2013 The diode is correct Dazz. Resistor boards look good too from what I can trace. Running your LED's at 3.3 volts? Link to comment Share on other sites More sharing options...
Administrators Dazz Posted March 4, 2013 Author Administrators Share Posted March 4, 2013 Im running them into the v1 booster board. It's got 5v and 12v connections. I know that 3.3v is from the orange cae from the PSI, but I'm not sure how I would add 3.3v. Link to comment Share on other sites More sharing options...
zebulon Posted March 4, 2013 Share Posted March 4, 2013 Run 3.3v from the power supply to the (+) side of your leds and run the signal (-) to the other side of the leds from the board. Make sure you ground the booster board to the ledwiz and the power supply and you'll be fine. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.