KL25Z Pinscape Randomly Unresponsive

[Spacegoogie]

For what ever reason my pinscape controller just stops working randomly; it's not disconeccting but just stops working ( unresponsive).

when I look at the board, its just a solid green or blue light not both.

I have had the same board and setup for about a year so I don't know what would have happened.

 

If I unplug and plug back in, it's fine, then again randomly stops working.

Yes, I have tried other USB ports, different usb cable, and disconeccting other USB things so only KL25Z is connected.

 

Again, nothing changed. This just started. A table can be launched, or not and it will stop working (not disconnecting, just not responsive with a green or blue solid light).

 

I have also gone through and made sure all USB ports in device manager were not allowing the computer to turn off USB devices to save power to no avile.

 

If anyone has information or can help, that would be awesome!

 

Thanks!

Edited October 6, 2024 by Spacegoogie
Light will be green or blue

[Spacegoogie]

On 10/6/2024 at 7:03 AM, Spacegoogie said:

For what ever reason my pinscape controller just stops working randomly; it's not disconeccting but just stops working ( unresponsive).

when I look at the board, its just a solid green or blue light not both.

I have had the same board and setup for about a year so I don't know what would have happened.

 

If I unplug and plug back in, it's fine, then again randomly stops working.

Yes, I have tried other USB ports, different usb cable, and disconeccting other USB things so only KL25Z is connected.

 

Again, nothing changed. This just started. A table can be launched, or not and it will stop working (not disconnecting, just not responsive with a green or blue solid light).

 

I have also gone through and made sure all USB ports in device manager were not allowing the computer to turn off USB devices to save power to no avile.

 

If anyone has information or can help, that would be awesome!

 

Thanks!

Forgot all about this. I fixed the issue a few days later.

In the pinscape program the  output config on some buttons were on the same port as others causing the KL25z board to become unresponsive. 

Made the correct changes and all is good and have had zero issues since.🍻