Content Provider 85vett Posted December 17, 2013 Content Provider Posted December 17, 2013 I upgraded to DOF today on my cab. What an amazing performance gain! All went smooth with the exception of one thing. On several of my tables my contactors, shaker motor, strobe, gear motor, etc worked but my RGB's were not working. After the help of many on this site (randr and Dazz mainly) and then sharing their DOF files I traced the problem down to the old legacy naming convention for solenoids 30, 31 and 32. With the old .ini file you had to convert those solenoids to: - S-32 = s-0 - S-31 = s-1 - S-30 = s-2 This was what caused my LED's to not work as every table that had one of these present it wasn't working. I converted them back to the standard convertion (S33 = S32) and all started working again. Just posting this more as a tip as I'm sure I'm not the only one that will run into this.
randr Posted December 17, 2013 Posted December 17, 2013 Glad you got it sorted! And good to know what the problem was for anyone else having the same issue. Sent from my iPhone using Tapatalk
Content Provider arngrim Posted December 17, 2013 Content Provider Posted December 17, 2013 You have also s-3 s29, and if i remember tables like whirlwind goes to s-8 Why don't you just create an account on configtool website, and grab the pregenerated configs according to your setup? Try it and let me know what you think of it, more than half of the table confihs are mine ;-)
Content Provider 85vett Posted December 17, 2013 Author Content Provider Posted December 17, 2013 I did but it was missing some of my problem tables. I wound up using that pre-conf and then added the tables I was missing manually.
Content Provider arngrim Posted December 17, 2013 Content Provider Posted December 17, 2013 what tables and problems r u talking about?
Content Provider 85vett Posted December 17, 2013 Author Content Provider Posted December 17, 2013 PM sent :-)
Recommended Posts
Archived
This topic is now archived and is closed to further replies.