oniri7 Posted January 19, 2023 Share Posted January 19, 2023 good morning, I've been trying for many hours to make the addressable leds of my pincab work with the Wemos board, I can't get it to work. The board seems to flash fine, it keeps doing RGB tests in a loop, but it doesn't interact with the vpx table. in config30.ini test it always gives error exception E127 magenta and from there derived from that exception... I don't know how to proceed. I have tried different installations, through different tutorials (montetoncab, tinytools...) and nothing. I would appreciate some light on the subject. regards Link to comment Share on other sites More sharing options...
djmdesign Posted February 4 Share Posted February 4 Did you ever figure this out? same issue, wemos d1 mini v4. tried zebboards firware aroz firmware I think you have to power the wemos and also use the usb, Im not sure but if you dont set 3v or 5v pin with power the board stays in a sleep mode?? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now