Jump to content

I tried to build a nucleo based 256x64 pin2dmd

zig

By zig
in Pin2DMD General Discussion

Recommended Posts

zig

zig

Posted
Posted

Hi everyone thought id give it a crack and try diy for some fun, so it is assembled and boots, I used the EVO 256x64 firmware as this is all that worked.

 

  1. I can configure the display in the on display menu.
  2. I used st-link V3-10-3 cant seem to downgrade as I did see this has caused issues in forum posts.
  3. it is activated.
  4. completed input test as per website.
  5. with an sd card in the slot it boots but if I reset the nucleo board while powered it seems to crash.
  6. plugged into a real pinball it remains on the boot screen.

 

Attached some photos of the chip sets used on board just in case I used the wrong ones.

 

looking for some next steps in troubleshooting.

 

Thankyou.

321238903_3439799643007570_1764844238260474307_n.jpg

320746032_1193315084946127_3568899261033165146_n.jpg

320711105_3366837783599389_587337318748233824_n.jpg

320046379_693386022465450_8021502506258740478_n.jpg

321051993_929461101761936_5254058980508883247_n.jpg

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

About VPUniverse

VPUniverse is a site dedicated to digital pinball simulations and anything pinball in general. Our primary focus is on Digital Pinball formats including Visual Pinball, Future Pinball, and many more pinball simulators. All content is provided on this site for free to all registered members.

Subscriptions are available that allow additional perks; such as reduced download timers and increased download speeds.

Digital Pinball Network - Beware of frauds!

DPNetwork is a network of sites that are fully supported by the Virtual Pinball Community. Support those people who create the content and download ONLY from the following sites. The people that create the content for this hobby post only on the following sites. Any site not listed here; is NOT a vetted site. Always know what you are downloading and from where you are downloading from.

Trusted Sites:

Site Content & Disclaimer

All of the content on this site is created by our community members. All content on this site are done in tribute to the original creations. Because our community members upload this content for free use; does not give ANYONE permission to re-host files, re-distribute, package, or sell any cabinets or drives with community created content.

By downloading from this site; you agree to not re-host community content, package or re-distribute in any form the content from this site. If you are caught; your membership on VPUniverse.com will be banned without refund.

Contact

VPUniverse Discord

×
×
  • Create New...