nekreg9 Posted October 21, 2022 Posted October 21, 2022 I have my Pinscape PWM outputs running to a MOSFET breakout board. Recently the start button has been on constantly. It just stays lit at full power. When I go into the Pinscape setup, I can hit the turn on for the start button and you see the light slightly produce less light. Then when I click off, it goes back to full brightness. Any clue what would be causing the issue? Is my MOSFET board going bad? I haven't touch anything in those setup, so the software should be good. Also since the setup shows some changing when I click on and off, the wiring should be ok. I'm at a loss what could be the issue. Thanks for the support.
barryodog Posted October 21, 2022 Posted October 21, 2022 My plunger button {enter} did the same thing even with no wire on board. I ended up moving pin location in pinscape to rectify. the off on would not change in pinscape, like it was froze
Recommended Posts
Archived
This topic is now archived and is closed to further replies.