Sainsmart board not detected by config tool

[tonycrew]

Hi i am new to this hobby, I have connected a sainsmart board via the usb and connected to solenoids from a 1up pinball cab, I have used the diodes etc, and it's not detected, So i removed the solenoids and it's still not detected, The official relkay tool sees it and can activate the relays.

Can anyone point me in the right direction please

[outhere]

Which one
the  8 relays or 16
if it's the 16 I don't believe that works with DOF but I could be wrong

[tonycrew]

Hi it's the 8 relay one

[tonycrew]

it just has the ledwiz config as an option

[hcj13]

.

[LAROUILLAS]

...??????

[hcj13]

10 minutes ago, larouillas said:

...??????

Sorry. Misunderstood the question.

[tonycrew]

when i run DofLinx i get this in the log

 

2022.09.17 11:47:28.042    FT245RBitbangController  with serial number AB0NX8WP has been initialized and the updater thread has been started.
2022.09.17 11:47:28.042    EXCEPTION: Could not open the connection to FTDI chip with serial number AB0NX8WP.
2022.09.17 11:47:28.042    EXCEPTION: Thread: FT245RBitbangController AB0NX8WP named  updater thread 
2022.09.17 11:47:28.042    EXCEPTION: Message: FT_EXCEPTION --> FTDI device not opened.
2022.09.17 11:47:28.042    EXCEPTION: Stacktrace:    at DirectOutput.Cab.Out.FTDIChip.FTDI.ErrorHandler(FT_STATUS ftStatus, FT_ERROR ftErrorCondition)
2022.09.17 11:47:28.042    EXCEPTION: Stacktrace:    at DirectOutput.Cab.Out.FTDIChip.FTDI.ErrorHandler(FT_STATUS ftStatus)
2022.09.17 11:47:28.042    EXCEPTION: Stacktrace:    at DirectOutput.Cab.Out.FTDIChip.FT245RBitbangController.Connect()
2022.09.17 11:47:28.042    EXCEPTION: Targetsite: Void ErrorHandler(FT_STATUS, FT_ERROR)
2022.09.17 11:47:28.042    Warning: No connection to FTDI chip AB0NX8WP. Updater thread will terminate.

[tonycrew]

Got it working didn't realize there's an option in the config tool to select your hardware