Rappelbox Posted May 30, 2022 Posted May 30, 2022 Well, the headline describes it basically... I have a PIN2DMD-XL Evolution board that is only booting if I hit the reset button... single press is enough but without it, no picture. Has anyone experienced this before? greets Dom
Content Provider lucky1 Posted May 30, 2022 Content Provider Posted May 30, 2022 I think so far only changing the CPU solved the problem.
Frankensteinowner Posted October 28, 2022 Posted October 28, 2022 I had the same problem with mine (same model of Pin2DMD) - initially, I dropped two wires off the card and shorted them out at the start of play - ended up hooking the reset of the DMD onto the rest of the driver card via a zener and a resistor (the driver card runs at 5V, the DMD at 3v3). regarding the above post, you've got to be pretty hot at soldering to change the CPU. I did try changing the capacitors in the reset circuit etc but, to no avail.
Crrispy Posted December 23, 2022 Posted December 23, 2022 Hello, I had this at the beginning with mine, it was a boot timing issue with the sd card that was fixed by Joerg with a new firmware, around 3.18. What's your fw version?
Recommended Posts
Archived
This topic is now archived and is closed to further replies.