Quitting a table

[tmpc]

I have 10.7 on two pc's and my cab, on one of my pc's when i press q to quit a table the bottom option just says quit and the other two says quit to editor.

How do i get the other to say quit to editor also?

 

Thanks.

[pritch33]

1 hour ago, tmpc said:

I have 10.7 on two pc's and my cab, on one of my pc's when i press q to quit a table the bottom option just says quit and the other two says quit to editor.

How do i get the other to say quit to editor also?

 

Thanks.

I think it depends on how you are opening the table what result you get .  Its normal on 10.7. Make sure you use the same method of opening a game across all systems and you should be fine. Off the top of my head not sure what the correct way is but it shouldn't take much to figure out.

 

[blanger]

On the machine that says "quit" are you loading the game with a front end like popper? on my setup if I use a front end to load it just closes the game, if I load the game directly from VPX I get the quit to editor.

[tmpc]

Thanks for the replies.

I do not have a front end on any of these setups, on the two pc's i click on the table from the tables folder inside visual pinball and get the different results.

I even removed visual pinball from the registry on the pc that just has the quit option with no change.

On my cab i made short cuts for the tables and put them in folders on my desktop, the cab and one of my pc's have the quit to editor option.

I have looked for some sort of setting that is different on the machines but so far found nothing.

 

Thanks 

[tmpc]

I found this happens when i install the full version of 10.7 and not just using the 10.7 exe.

Is there a way to get this to say quit to editor with the full install of 10.7.

 

Thanks