SCPinballer Posted September 10, 2021 Posted September 10, 2021 Installed puppack. Deleted B2S file. The opening screen where it draws a bunny plays on the backglass but it never seems to fire any triggers to play anything else. Stays on that screen the whole time. Anyone can offer help?
brandonkelley Posted September 12, 2021 Posted September 12, 2021 The Pupback is based on DMD images, so my guess is you dont have the normal DMD and therefore the triggers from the DMD are not occurring.
bushav Posted September 12, 2021 Posted September 12, 2021 When I first tried Pup Packs it was very frustrating. My videos would freeze and if I ran task manager I could see that the video program was opened multiple times. After revisiting the issue over several months I finally figured out it was a conflict with "administrator privileges'". Until a couple of years ago aspects of VPX were suggested to run in administrator mode. That is no longer the case and if you have enabled that mode it will have a conflict with Pup video playback. At least that was my issue. I went through and unchecked all the pinball plugins that had administrator privileges and everything is better now.
tligu Posted October 17, 2021 Posted October 17, 2021 Same problem, did you find a solution SCPinballer ? tligu
Bluesky2095 Posted November 4, 2021 Posted November 4, 2021 Does anyone know the solution to this please?
ty8eefj8vvvvjeeipa Posted February 11, 2022 Posted February 11, 2022 go into the table through Visual Pinball and hit F1 to load the options menu. At the bottom, check the last enable DMD selection and hit Q twice to exit the table. Save and reload and then you should be good. At least that worked for me
Numiah Posted October 27, 2022 Posted October 27, 2022 This pack used to work, but now several puppacks (ACDC as well) don't get triggered anymore. Only overlay is showing the drawed bunny. Others work fine. I am baffled and of course tried everything Nailbuster suggested on his site. Weird huh?
Numiah Posted November 1, 2022 Posted November 1, 2022 On 10/30/2022 at 2:09 AM, Androctonus said: check the dmddevice.ini [pinup] enabled=true OMG! How on earth did I miss this setting? I have checked a gazillion times and was baffled since it worked earlier on. I must have somehow overwritten the .ini file... Eek! Everything is working again as it should. THANK YOU so much!
Boroka Posted November 10, 2022 Posted November 10, 2022 On 11/1/2022 at 4:09 PM, Numiah said: OMG! How on earth did I miss this setting? I have checked a gazillion times and was baffled since it worked earlier on. I must have somehow overwritten the .ini file... Eek! Everything is working again as it should. THANK YOU so much! 👍
Windbury Posted September 8, 2025 Posted September 8, 2025 does anyone know where to find this pup-pack now? the link to it no longer works
Windbury Posted October 12, 2025 Posted October 12, 2025 On 9/7/2025 at 10:14 PM, Windbury said: does anyone know where to find this pup-pack now? the link to it no longer works I managed to find it, for anyone else looking for it it is here: Go to the comments, it's the 13th comment down
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now