Jump to content

changing 12v pin strip to molex connector on pin2dmd 128x32

scoby78

By scoby78
in Pin2DMD General Discussion

Recommended Posts

scoby78

scoby78

Posted
Posted

Hi Lucky,

 

Can you please advise how I can change the manufacturing files so that I can put a molex connector (like on the 5v side) on the 12v pin strip for the pin2dmd 128x32?

 

Many thanks

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

About VPUniverse

VPUniverse is a site dedicated to digital pinball simulations and anything pinball in general. Our primary focus is on Digital Pinball formats including Visual Pinball, Future Pinball, and many more pinball simulators. All content is provided on this site for free to all registered members.

Subscriptions are available that allow additional perks; such as reduced download timers and increased download speeds.

Digital Pinball Network - Beware of frauds!

DPNetwork is a network of sites that are fully supported by the Virtual Pinball Community. Support those people who create the content and download ONLY from the following sites. The people that create the content for this hobby post only on the following sites. Any site not listed here; is NOT a vetted site. Always know what you are downloading and from where you are downloading from.

Trusted Sites:

Site Content & Disclaimer

All of the content on this site is created by our community members. All content on this site are done in tribute to the original creations. Because our community members upload this content for free use; does not give ANYONE permission to re-host files, re-distribute, package, or sell any cabinets or drives with community created content.

By downloading from this site; you agree to not re-host community content, package or re-distribute in any form the content from this site. If you are caught; your membership on VPUniverse.com will be banned without refund.

Contact

VPUniverse Discord

×
×
  • Create New...