Jump to content

Recommended Posts

Just wondering if there are any step by step instructions for using the V4 boards with the smaller and bigger displays.

For the 128x 16 is it just a matter of using the 128x32 displays and putting the correct firmware on the board. Probably also need to sort out the mounting holes on the acrylic? I note on the EVO a ROM is on the actual EVO board, but I take it this is not required for the V$ setup.

Link to comment
Share on other sites

  • Content Provider

To get 128x16 working you additionally need the 128x16 DMD Controller board https://github.com/lucky01/PIN2DMD/tree/master/hardware/128x16 CONTROLLER but maybe this is interesting for you 

For 192x64 you need 3 x P2 panels like these e.g https://de.aliexpress.com/item/32967082722.html the pin2dmdXL firmware and a key for pin2dmdXL


Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...