Jump to content

Plunger Kit Problem


RetroWill

Recommended Posts

Hi

I'm new to this lark and I am attempting to build my own Pinball Machine.  I purchased a plunger kit which came with a Williams/Bally plunger and Potentiometer.

My issue is when I put the plunger into the table although its flush on the outside of the cabinet the actual plunger bar is not horizontal and it noticeably pointing slightly upwards.  I took the plunger to one side and checked to see if it was square but it doesn't seem to be and I was wondering is this the way its supposed to be?

This is a photo: http://prntscr.com/t7zin7

 

Thanks in advance

Will

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
  • Create New...