Dany Posted August 25, 2019 Share Posted August 25, 2019 hi all I need a hand I can't program in DFU mode someone can show me the steps to be done thanks Link to comment Share on other sites More sharing options...
Content Provider lucky1 Posted August 25, 2019 Content Provider Share Posted August 25, 2019 1. place the jumper like this on your nucleo board 2. power your Nucleo using the ST-Link USB 3. connect the second user USB to your PC 4. if you start the DFUSeDemo you should see the Nucleo board as "STM32 device in DFU mode" 5. follow the installation as described under 1.2 here https://pin2dmd.com/installation/ Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.