vlgxejme Posted September 3, 2018 Posted September 3, 2018 Hi I have a pin2dmd with the firmware 2.58. I'm no longer able to adjust the brightness in the pin2dmd app. Any idea? I use pin2dmd.exe latest rev 2.53 thanks
Content Provider lucky1 Posted September 4, 2018 Content Provider Posted September 4, 2018 I just tested with the latest firmware and pin2dmd.exe and had no problem. Is it running at full brightness ? If yes there could be a problem with the OE (enable) signal of the panels
vlgxejme Posted September 4, 2018 Author Posted September 4, 2018 yes it always run at full brithness. What do you mean by OE signal. Can I do something?
Content Provider lucky1 Posted September 5, 2018 Content Provider Posted September 5, 2018 Check the connection from the controller to the panel. OE is PIN15 on the HUB75 connector.
vlgxejme Posted September 9, 2018 Author Posted September 9, 2018 I dissemblable the shield off the unclesash board, ans everythinks seem to be fine. I'm prety sure taht the brightness button was usable on the 2.55 firmware... It is possible to downgrade to it to make a test? and if so, where can I find the firmware since there is only the latest on github
Content Provider lucky1 Posted September 9, 2018 Content Provider Posted September 9, 2018 You can use the history button when you select a file to get older versions https://github.com/lucky01/PIN2DMD/commits/master/firmware/latest/V3 STM32F4 DISCOVERY/PIN2DMD.bin
Recommended Posts
Archived
This topic is now archived and is closed to further replies.