rx2006je Posted August 27, 2018 Share Posted August 27, 2018 So I got several tables where i can insert coins and the plunger works but when i hit the start key a ball never shows up to play and suggestions Link to comment Share on other sites More sharing options...
Thalamus Posted August 27, 2018 Share Posted August 27, 2018 You are not trying to start a table named something with PM5 in it with VP9 ? If so. You need to start PM5 tables with Physmod. Link to comment Share on other sites More sharing options...
DJRobX Posted August 27, 2018 Share Posted August 27, 2018 Another thing to check is that you don't have an uncalibrated game controller plugged in. If VP thinks it's a motion sensor it may be prohibiting the ball from making it out of the trough. Link to comment Share on other sites More sharing options...
Thalamus Posted August 27, 2018 Share Posted August 27, 2018 Good point. Link to comment Share on other sites More sharing options...
rx2006je Posted August 28, 2018 Author Share Posted August 28, 2018 No none of the tables are named anything with pm5, and I am currently using a keyboard as the controller and dont see where to check calibration. I have many other tables that play fine but just a few that wont load a ball. etting on the dmd and wont start. Link to comment Share on other sites More sharing options...
Thalamus Posted August 28, 2018 Share Posted August 28, 2018 Staying in factor settings is normal for the first time you start the game. That is when there is no rom info to read. Restart and it will have saved the nvram file and you should be ok. I don't know what to look for about the other problem. Need more info. Exact table is a good start. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.