Coin Door Pinout Documentation

[bill0r]

Hi,

 

Can anyone point me to a document explaining the pinout of the wiring harness on aWilliams/Bally coin door? Specifically this Williams/Bally one from PF:

http://www.pinballlife.com/index.php?p=product&id=13

 

Thanks!

[gtxjoe]

If this is for a virtual cab, you could just use this coin door.  You need coin mechs but you also needed them for that Williams door

http://www.pinballlife.com/index.php?p=product&id=628

 

 

To wire this door up, there are 2 coin switches which you connect to your ipac and provide 5v to the bulbs (or maybe 12V depending on the bulb type)

[randr]

You really need a full door I wires up all switches so when I open door pinmame sees door open and I can do rom changes just like real pinball with switches on door. Just use a meter and check wires it's very simple if you need a diagram I can provide one but it's very simple. Only one I didn't wire was the slam tilt otherwise I used all wires

[Geek]

I know this is an old post but @randr do you still happen to have a wiring diagram? I have an iPAC and a VPIN board/plunger setup I am working on as I build my cabinet