kruuth Posted February 18, 2016 Share Posted February 18, 2016 I was just wondering about this, going through the tool, like if I have 8 bumper left and 10 bumper middle left or back left, what do each of these mean? Does that mean that the 10 bumpers are above the 8 bumpers on the table or are further back? Link to comment Share on other sites More sharing options...
Content Provider allknowing2012 Posted February 18, 2016 Content Provider Share Posted February 18, 2016 If you have 8 relays you can simulate 8 bumpers .. if you have 10 relays you can simulate 10 bumpers. Here is my config based on where my solenoids/relays are physically located inside my cabinet. Now Arngrim overlaps the table configs such that if you dont have say "10 Bumper Center" defined, it will also bang our "8 Bumper Center". My port assignments seem to cover all the basics found in most tables. Link to comment Share on other sites More sharing options...
Content Provider gtxjoe Posted February 18, 2016 Content Provider Share Posted February 18, 2016 Here is the 10 solenoid layout from Arngrim . 8 you would eliminate the Back Left and Back Right, I assume Link to comment Share on other sites More sharing options...
Content Provider arngrim Posted February 18, 2016 Content Provider Share Posted February 18, 2016 to be more precise, let's say that the bumper back of the 8 bumper configuration is almost not mapped and during the time less and less over the dof reviews, so i would say if you remove the 3 bumper back from the 10 bumper schema, this is how the 8 bumper configuration looks if you move the bumper middle between the back and the middle Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.