Content Provider lucky1 Posted May 13, 2020 Author Content Provider Share Posted May 13, 2020 O.K. that is a old board from pinballSP. I never had one of those and schematics are not public. As far as I know you need to change the DIP called boot and then reset / power cycle to put it into DFU mode. Link to comment Share on other sites More sharing options...
Banzaipinball Posted May 14, 2020 Share Posted May 14, 2020 Thanks, tried everything, just can't seem to get the dfu software to recognise the dmd, it does show in the computer control panel Link to comment Share on other sites More sharing options...
Content Provider lucky1 Posted May 14, 2020 Author Content Provider Share Posted May 14, 2020 If the device name is STM32 BOOTDEVICE you need to install the driver from the DFUSE folder. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.