Eddypin Posted January 15 Posted January 15 Bonjour, Je suis sur un projet de remplacement d'un DOT matrix sur un flipper DATA EAST MAVERICK J'ai donc utilisé un PIN2DMD en assemblant un SHIELD V4 et en utilisant une carte NUCLEO. J'ai installé le FIMWARE PINDMD_XL et j'utilise 3 panneaux LED pour avoir un écran 192*64. Tout se passe bien, j'ai mis la clé d'activation mais lors du test INPUT, j'ai parfois INPUT 11 CLOSED, parfois INPUT 7 CLOSED alors que je ne branche rien sur le connecteur qui doit être relié au flipper! J'ai essayé de changer de FIRMWARE PIN2DMD et STM32, mais j'ai toujours le même problème. Avez vous déjà rencontré ce problème? Actuellement j'utilise le firmware ST32 V2.J47.M34 et PINDMD V4.52
Content Provider lucky1 Posted January 16 Content Provider Posted January 16 Are you sure you use the right resistor array on the input ? It needs to contain seperate resistors like on the picture on the bottom https://de.wikipedia.org/wiki/Widerstandsnetzwerk#/media/Datei:Widerstandsnetzwerk.svg
Eddypin Posted January 18 Author Posted January 18 bonsoir, j'ai mis ce type de résistance 4608X-102-221LF ce sont bien des résistances séparées
Content Provider lucky1 Posted January 19 Content Provider Posted January 19 Then I would next check and measure the traces from the input header to the STM32 and against Ground.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now