VPX 10.8 Bad Cats and Total Annihilation orientation issue.

[bigmike20vt]

Hi

I am not a complete novice at setting up my VPX 3 screen cabinet however these 2 tables are causing me some issues and wondering if anyone can help please.

 

the Bad Cats one is 3.1 from VPW and when i load it the settings area where i can normally change the orientation is completely blank.   As default most tables are 270 degrees however i have to swap all mine to 90 degrees.  As it stands the table runs beautifully ........... but its upside down.

 

Total Annihilation is similar but slightly different.

That one has the settings there, I can change it from 270 to 90 degrees and save it. The save does hold on reloading i can see it is now set to 90 degrees........ however it is still upside down.

 

all my other tables i can configure fine so I think it is down to the tables rather than me.    Does anyone have any ideas?

 

Many thanks

Mike.

 

EDIT  typically 10 mins after posting i figured it out.  leaving here incase it helps someone else.

 

Bad Cats  the settings were not editable in vpx however i could still hit start and save settings within the table. this then created an ini file which when i opened was set to 270 degrees, i could then edit that in notepad to 90 degrees... now works fine,

 

Total Annihilation  similar story.  the settings for orientation whilst visibly changing in VPX were not updating in the ini..... i manually changed that one and now that too is fine.

 

no idea what the issue is with those tables however i will take that as a win.  

 

happy balling!.

Edited October 14, 2025 by bigmike20vt
update