[SOLVED] DOF is not working anymore although active in B2S

[MisterCoffee]

Hi,

I don't know what I adjusted. But suddenly all the solenoids, fans, etc. are dead.
The LEDs are still working perfectly via Teensy.

Actually, I just tinkered with VpinMame a bit, I think. Everything works there, too.

 

I have a Pinscape and two Teensys.

When I open the Pinscape Config Tool and control the solenoids manually, they work. Only via DOF, they don't.

The ports for the individual solenoids are set correctly.

The checkbox is checked in B2S, and I can press the button. It says active there, with no errors.

 

However, the log file says:
- Warning: No table config file found. Will try to load config from LedControl file(s).
- Will try to load configs from DirectOutput.ini or LedControl.ini file(s)...

 

Could this be the error I need to fix?

 

I unzip all the files I download from the DOF Config Tool into the DOF\Config folder. For example, the three ini files 51, 30, and 31.

My DOF dll's aren't blocked, I had installed the MSI files from MJR.

While searching for the error, I re-registered the B2S server, reinstalled DOF, and registered the x86.

I generally use 32-bit and 64-bit versions.

 

I hope you can help me.

I just can't find the error.

 

Thank you.

Mr.Coffee

Edited October 6, 2025 by MisterCoffee

[MisterCoffee]

Solved.

I had a bad line in the cabinet.xml.

Funny, as the LEDs were the only part that worked fine. I have read somewere that DOF stops loading when there are to many errors. The errors were at the very buttom of my log file.

Took me about 5 hours to figure it out 🙂