ZB Ball Launch - Die Hard Trilogy and Last Action Hero

[WiredRacing]

Hi folks,

Pinscape, I have the ZB turned on, pointing to output 23, executing an Enter, push distance as default recommended 0.063. At the bottom, under "feedback device outputs", 23 says 'virtual' and has the ball launch icon next to it. I have calibrated the plunger, there's plenty of travel when pushing.

 

DOF seems to be working ok.. shaker goes and launch (pushing the plunger) works in T2, Indiana Jones, AFM, GnR, Monster Bash, ST TNG, SW Trilogy... but not these two, which the DOF config shows is set to ON. 

 

As near as I can tell I have the most recent tables. 

DH Trilogy Table is 0.98

LAH Table is VPW 2.0

 

Is there something I'm missing?

[WiredRacing]

Nevermind. There were two issues.

 

First was old directoutput.ini was in there, which had values in for ZB rather than "ON", seems these were getting prioritized over the directoutput##.ini I had been updating for the pinscape.

 

And the other thing was I forgot I had to load these tables in VPX 64-bit... and I didn't have DOF 64-bit setup. 

 

ZB Launch is now working mid-game and also now on DH... surely will be working on LAH too now.