VPX and Dude's Cab nudging not working

[JamsterJulien1968]

Hey all,

 

I'm just setting up my cabinet and I can't get nudging to work in visual pinball X. 

The dude's cab configurator is showing movement for the accelerometer, nothing happens in a table (Addams Family or Bride Of Pinbot tested).

 

ChatGPT is telling my Dude's Cab should install a virtual joystick, and VPX uses that for a analogue input - is that correct ? I have nothing in my device manager for that.

 

I have the following ticked in VisualPinballX : 

 

Enable Nudge Filer

Enable Analog Nudge

Normal Board Mounting Orientation

Analog Nudge Input Is Velocity

Tilt Sensitivity : 800

 

My cab is running Windows 11.

 

Any assistance would be greatly appreciated !

Edited August 13, 2025 by JamsterJulien1968

[deadmanworking]

You might need to bump up the sensitivity in the Dude's Cab setup quite a bit, I have mine at 800%.

Then check again that you have X-axis and Y-Axis set with the Axis alignment. (I have my Y axis inverted also.) My values are X-Max 100 and X-Gain 150%.

Then try the Nudge calibration test table that comes with your installation and see if you get any response at all. 

[Rappelbox]

9 hours ago, JamsterJulien1968 said:

Hey all,

 

I'm just setting up my cabinet and I can't get nudging to work in visual pinball X. 

The dude's cab configurator is showing movement for the accelerometer, nothing happens in a table (Addams Family or Bride Of Pinbot tested).

 

ChatGPT is telling my Dude's Cab should install a virtual joystick, and VPX uses that for a analogue input - is that correct ? I have nothing in my device manager for that.

 

I have the following ticked in VisualPinballX : 

 

Enable Nudge Filer

Enable Analog Nudge

Normal Board Mounting Orientation

Analog Nudge Input Is Velocity

Tilt Sensitivity : 800

 

My cab is running Windows 11.

 

Any assistance would be greatly appreciated !

uncheck "Analog Nudge Input Is Velocity"

[JamsterJulien1968]

Thank you ! That worked !