Pinup Popper delay after exiting tables

[gman80612]

Hello all.

 

I posted this on r/virtualpinball on Reddit but didn't get much of a response so I thought I'd try other places.  Thanks in advance for any help!

 

My system is  an Intel i7-5820 @ 3.3GHz with 16GB RAM.  The video card is NVDIA GeForce GTX 1080.   It was suggested in that Reddit thread that my CPU was not powerful enough but I have a hard time believing that's why it lags after exiting games.

 

------------   original post below    -------------------------------

After exiting tables, my Pinup Popper interface comes back up but my system lags for about 5 seconds (until the wheel banner fades out) before I can make any selections (back, flippers to change selected game, etc). Once the banner fades out, I can pick a different table, go back, exit, etc.

 

Is this normal? I don't think there was that lag when I originally installed everything but I can't remember for sure. Everything else runs and works fine, it's just the ~5 second lag after exiting tables. After installing and tweaking so many tables, I don't want to start from scratch just to see if that fixes a minor inconvenience.

 

Thanks in advance for any suggestions!

 

------------------------------------

[zack06007]

Hello Have you find a solution? I have same problem (Rtx 3080)
 

Yesterday, no lag for me when i launch pinup - or when i quit table to launch another one
Today, i wait 5-8 sec for navigate on pinup - after this 5-8 sec no problem....

 

If i erase cabinet.xml: no bug but no led
If i take it the 5-8 sec bug come back

I restore to 6 june with AOMEI and same problem - but last week my pincab haven't freeze on pinup

Who have solution?

- I have try to withdraw USB Teensy: Same problem
- I have try to restore with AOMEI: Same problem
- I have withdraw cabinet.xml : No freeze, it's ok !!!! but no LED

I'm in pinup 1.5 - Vpx 10.8 RC4 - Vpmame 3.6

Thx for yout help

Edited June 30, 2024 by zack06007

[zack06007]

I have resolve my problem

My enter 16 is on all of the Time (bug of musfet)

I have eject this enter and it's ok 

[chuckda4th]

On 7/2/2024 at 4:25 PM, zack06007 said:

I have resolve my problem

My enter 16 is on all of the Time (bug of musfet)

I have eject this enter and it's ok 

Have the same issue. What’s an “enter 16” and how/when do you turn it off?

[zack06007]

on pinscape see if you have all of the time entry (input) /sorties (output) ON

If yes, it's possible on pinscape to off this

[chuckda4th]

Finally fixed this 6mo later, albeit unintentionally. 
 

I was having issues with other parts of my cab and ran through these instructions effectively rebuilding the VPinMAME folder: 

 

 

All is good now…