KiwiBri Posted June 14, 2017 Share Posted June 14, 2017 Hi, I am using a DOF setup that is working with 10 12v solenoids. Everything seems to be working fine, then occasionally at the start of PinballX the left flipper will not fire the DOF. The PinballX receives the input as I see the screen scroll. If I try right flipper immediately afterwards it fires the solenoid, then if I try the Left Flipper it now works... and keep working. I have seen similar behavior in game. Sometimes left flipper DOF is not firing solenoid, but flipper flips, then after using the right flipper, the left one will fire. Not sure if this is co-incidence or not, but I have used different solenoids and get the same issue happening . All solenoids are connected to a 12v line of a secondary PSU in the cab. Any tips/help would be appreciated. thanks Link to comment Share on other sites More sharing options...
KiwiBri Posted June 22, 2017 Author Share Posted June 22, 2017 i guess everyone's system worked first time Link to comment Share on other sites More sharing options...
rambo3 Posted June 24, 2017 Share Posted June 24, 2017 Ain't happenin' to nobody I had some issues with my flippers getting stuck actually on the Ultimate I/O where support was based on the PacLed64. Turns out it was an issue in the code hammering the poor UIO so much it started missing / skipping commands, in effect causing stuck flippers. Link to comment Share on other sites More sharing options...
KiwiBri Posted July 26, 2017 Author Share Posted July 26, 2017 Just following up on this. I haven't experienced this issue again in the past weeks. All seems to be working ok now Sent from my SM-G935W8 using Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.