DOF port assignments assistance needed

[bdaley6509]

I purchased a used virtual pinball with an LED wiz.  Is it possible to retrieve the port assignments from the files in the DirectOutput directory?  (they have been configured but the table list is outdated) and would like to make a new config tool profile.  No doflinx has been configured.  Tracing the wires to the ledwiz seems like a chore by glancing in the cab.  Thanks ahead of time.

[elmera]

Update: I just realized the cabinet.xml file will only show the DOF ports for LED strips.  I'm not exactly sure where/how to find the ports for other DOF devices.  

 

For the LED strip port assignments look at your c:\DirectOutput\configs\cabinet.xml file.  They should be listed towards the bottom. 

 

 <LedWizEquivalentOutput>

          <OutputName>Back Matrix</OutputName>

          <LedWizEquivalentOutputNumber>1</LedWizEquivalentOutputNumber>

        </LedWizEquivalentOutput>

        <LedWizEquivalentOutput>

          <OutputName>Left Side Playfield</OutputName>

          <LedWizEquivalentOutputNumber>4</LedWizEquivalentOutputNumber>

        </LedWizEquivalentOutput>

        <LedWizEquivalentOutput>

          <OutputName>Right Side Playfield</OutputName>

          <LedWizEquivalentOutputNumber>7</LedWizEquivalentOutputNumber>

        </LedWizEquivalentOutput>

[bdaley6509]

Thanks.  A good place to start.

[elmera]

Sorry I couldn't help more.  I use a KL25Z and not a ledwiz.  I'd think whatever software used to program the ledwiz would be able to test the ports so you could map out what it connected to each output.  Perhaps there are even labels assigned that could be read from the software, but again, I'm not familiar with using a ledwiz.