psmmacker Posted February 17, 2017 Share Posted February 17, 2017 Hi i used 24o volt cable brown + to red + and blue - on black 5volt use terminals blocks on sash sheild as it holds the higher amps better and much tidyier Also use the same thick cable on powering the stm as the panels As it gives a lot better clearer signaling and wire Panels together gives a good solid stable gound and capictors are for each led row Look at pics for example wiring u also removed removed all,jumpers on the stm32 discovery except thr next to the mcu chip These are as follows the 2 under the board and thr 2 side by side as they are not needed for anything Thanks Paul So use one cable from power pack tie down earths on panel and stm32 discovery Jumpers to remove st link ones but remember you may need to but put back to upgrade firmware and took off once program The 2 underneath each side of the stm Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.