Jump to content

Hyperpin And New Virtuapin Plunger


zeenon

Recommended Posts

So I narrowed down most of my minor issues now that I have a virtuapin encoder/plunger and no longer using a keyboard and I'm left with one PITA issue.

In Hyperpin I can not exit a VP or FP table with the virtuapin encoder that I just got. I've been using a keyboard for the last 2 months testing and 'E' (long and short) works every time (and still does) but Button 8 - Exit table on the controller does not. I ran joy.cpl and tested the button so it's not a hardware issue but software related. Any ideas?

Z

Link to comment
Share on other sites

Oh so close now.......

 

I changed the up/down/enter keys to the below highlighted and now I can navigate in the exit menu.

 

[FPLaunch]
exitEmulatorKey=Joy8
exitScriptKey=q & s
exitKey=Joy8
exitKey1=p
enterKey=1
enterKey1=Joy9
upKey=LShift
upKey1=Joy10
downKey=RShift
downKey1=Joy2

 

I put Joy8 for exitkey and exitemulatorkey and that pulls up the exit menu, but the only issue now is it also pulls the VP exit menu. So at this point I have the ability to exit but not pause. The VP exit key is set to the default 'Q'.

 

Z

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
  • Create New...