New stm32 discovery plastic enclosure and a outside metal tape inside and surrounding shell and rewire of 5+ and 5- 2 pins to each rgb panel

[psmmacker]

Hi been thinking of making a stm32 discovery plastic enclosure to keep to top gio pins covered from

Static electronic  interference and radio interference as the boards are naked

The shield also may fit the out side the box and g i/o pins would have 2 cut slots for easy sheild access would not need 5 volt and usb access plus the hub 14 pin input and hub 75 output

Of enclosure cut out anyone with auto cad  could design a 3d image would be helpful let me know who you people think  i used a chinses food take away box and some tin foil put loads of black tape

Over the foil so the shield dont short on pins i tought of this idear as i fix mobile phones and pc and also wondered why there is metal sheilds over the chips on the mobile ics

And reply thanks paul

As from 9/02/2016

As from tonight i tested my tempary in closure and looks before i added the surrounding metal around the stm32 discovery 

The rgb signal seems more stable and it could be down to electronic and radio interference 

I also used some header male ends to wire from usb to powers the panels using 2 pins on each panels

5 volt + and gnd panel left

5volt - and gnd panel right