AndersE Posted March 31, 2016 Share Posted March 31, 2016 Why is it not possible to begin a RGB config at port 16? When i do so, port 17 and 18 show the G and B, but after i save, 17 & 18 is empty. Is it because they belong to another ledwiz "bank" ? What should i do if i REALLY want to "cross bank" config? Wondering because i will run all banks at the same powersupply. Update: can't be because it is another bank, because it works starting an RGB config at output 8. Link to comment Share on other sites More sharing options...
Content Provider arngrim Posted March 31, 2016 Content Provider Share Posted March 31, 2016 configtool adapts to force feedback softwares, dof transforms effectx red to effetcx i48,effectx i0,effectx i0 Link to comment Share on other sites More sharing options...
AndersE Posted March 31, 2016 Author Share Posted March 31, 2016 Ööhhh? What? Link to comment Share on other sites More sharing options...
Content Provider arngrim Posted April 1, 2016 Content Provider Share Posted April 1, 2016 in short that's how it is a rgb toy to port 1 is port1 red, port2 green, port3 blue Link to comment Share on other sites More sharing options...
AndersE Posted April 1, 2016 Author Share Posted April 1, 2016 I don't think you understand me. Yes i know that an rgb led takes 3 ports each. I have configured port 1-15 for various magnets and motors. On port 16 i start to configure a rgb led: When i select an rgb led to begin at 16, green and blue configures at port 17 and 18 automatically. But after save, 17 and 18 is gone. WHY can't i use 16,17,18 as rgb output? Link to comment Share on other sites More sharing options...
Ginsonic Posted April 1, 2016 Share Posted April 1, 2016 I know, what AndersE means, please let me explain: 16, 17 and 18 in fact are allocated for R, G and B, it is only a display problem on the DOF config webpage, which happens only on column breaks (16/17, 32/33 and 48/49). Probably Arngrim will confirm ! Link to comment Share on other sites More sharing options...
AndersE Posted April 1, 2016 Author Share Posted April 1, 2016 Ahaa i never tested the full config and never thought it perhaps was just a glitch in the webcode. Ahh so i can also start a new rgb led on board 1 (port 32) and continue on board 2 port 33. Thats good. Thanks for understanding me Ginsonic Link to comment Share on other sites More sharing options...
Content Provider arngrim Posted April 2, 2016 Content Provider Share Posted April 2, 2016 ok i understand now, yes it is just a display issue, i saw it what is your board 2, another controller? Link to comment Share on other sites More sharing options...
Ginsonic Posted April 3, 2016 Share Posted April 3, 2016 I guess that AndersE means Port ( +, R, G and B ) not Board, please correct me, if I am wrong ! Link to comment Share on other sites More sharing options...
AndersE Posted April 6, 2016 Author Share Posted April 6, 2016 Ginsonic: your explanation of it being a configtool display glitch explained enough for me Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.