Jump to content

Help With Initial Dof Setup


Mikespinball

Recommended Posts

First time posting and hoping the community can help me out here. I have setup DOF recently to get the full effect out of my WIP cabinet. I am using zebs board to control contactors, solenoids, RGB and strobe bar, under cab RGB led lighting, two sets of RGB led flippers, fan, knocker, gear, and shaker motor. Took me a while to get things working and I thought I had it figured out but apparently still don't. The config files have me confused. I used DOF config tool and setup port assignments for my pacled 64 which is connected to my zebs board. I have tested all the toys thru led blinky and know that everything works and is on the right port. I saved the dof config file which was an XML and put that unzipped into the Directoutput config folder. Some features work but most don't ...specifically the RGB flippers, undercab lighting and fan. This is where my question comes in. Do I have to save a specific config for each table and if so how and where does it go. I go to table configs on dof configtool and for example twister???I see the custom config showing what toys will work on that table. I try to generate config at the bottom of the screen and it makes another dof config XML for my toy locations just like the original one I already saved into my config folder. Am I doing something wrong?? I also read up on the global config file and went into the global config editor and clicked save. It created a small global config XML that i put In my direct output folder. What does that do and do I need it. Any help would be greatly appreciated. Spent the last two weeks wiring all the toys I have been stockpiling and it's very discouraging not be able to put them into action. I have read the GitHub dof pages multiple times and find it very lacking for intial setup procedures.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
  • Create New...