mountainman Posted January 13, 2015 Share Posted January 13, 2015 I have a new Williams knocker I need to install in my DIY cab. I assume that you mount it near the top corner of the backbox against the side wall and fire it straight up to the separate knocker plate on the top? (i.e up and down) Does anyone know the distance the end of the knocker pin should be from the plate? Thanks a ton! Can't wait to use it! Link to comment Share on other sites More sharing options...
randr Posted January 13, 2015 Share Posted January 13, 2015 I hold plunger of knocker flush with bottom of solenoid using my thumb and top of plunger should be touching top of cab and screw it down. I think it's around 3/4" but never measured it. Make sure it's straight up and down Link to comment Share on other sites More sharing options...
mountainman Posted January 13, 2015 Author Share Posted January 13, 2015 Thx randr! That helps a bunch! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.