bhudkins Posted April 8, 2014 Share Posted April 8, 2014 Hi Everyone, I am looking for some input. Was adding some new tables to the cabinet today and ran into a problem with 3 or 4 of them. Attack From Mars, Funhouse and Insane Clown Posse were 3 of them. Game loads fine, once I hit the coin button and start the ball takes off and shoots all over. Usually never gets near the flippers but will go up and down and all over. Below is a link to a video of it with AFM. Any ideas? Out of 420 tables, only these few have this issue. Thanks! http://youtu.be/KMuJ3t8IN_Y Link to comment Share on other sites More sharing options...
Content Provider arngrim Posted April 8, 2014 Content Provider Share Posted April 8, 2014 Which vp version do you use? Link to comment Share on other sites More sharing options...
Content Provider gtxjoe Posted April 8, 2014 Content Provider Share Posted April 8, 2014 Also Try unplugging all your USB device except keyboard and see if problem goes away. Add back in you devices one at time. There might be something in the script triggering off a device Link to comment Share on other sites More sharing options...
bhudkins Posted April 8, 2014 Author Share Posted April 8, 2014 Thanks, I am using the latest nightly build from the download section. I think the only USB device plugged in is plunger controller and the wireless keyboard and mouse dongle. Link to comment Share on other sites More sharing options...
Content Provider gtxjoe Posted April 8, 2014 Content Provider Share Posted April 8, 2014 It's probably analog plunger/nudge related I don't have one so can't help, but if that is it try to additional google searches or someone here can chime in. Hopefully just a script change to fix it... Link to comment Share on other sites More sharing options...
Administrators Dazz Posted April 8, 2014 Administrators Share Posted April 8, 2014 This looks like it has something to do with config of the plunger/nudge device. Go into device settings in Windows and try to re-calibrate. Link to comment Share on other sites More sharing options...
bhudkins Posted April 8, 2014 Author Share Posted April 8, 2014 Thanks Dazz I went into calibration, and it looked ok. I hit calibration, then i cancelled it. Tried the tables again and they worked fine. Go figure Thanks! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.