By UncleSashA short instructions, how you connect your Pin2DMD WiFi Module into your HOME Network.
By UncleSashsimple HOW-TO connect the DC-DC Voltage converter
By UncleSashThis is a General Schematic for the Pin2DMD with a STM32F407VGT6 Controller.
RGB DMD Output (HUB75) real Pinball DMD Input Signal Enancer for real DMD Input SD Card reader very Basic drawin but very usefull, to get all the Pins right.
For more (like the Original Eagle file or correction in the Drawing), feel free to contact me.
By UncleSashThat's are the Schematic and Layouts from my Shields.
rev 1.2 (schematic and PCB Layout) rev 1.3 (schematic and PCB Layout) rev 1.4 (schematic and PCB Layout) rev 2.0a US (schematic and PCB Layout) rev 2.0c US (schematic and PCB Layout)
because, I still believe in the OpenSource!
When anybody wants or need the Eagla File, just send me a PM or go on my Facebook page and send me there a PM.
I still have the OpenSource Code from the OLD Firmware version 1.37, also able to send it after a PM.. yeah it is Open Source and you don"t need a key!
I like to upload the Open Source Version here, when the Admin will allow that to me.
By UncleSashGerman Version of the "DIRTY emergany SD Card reader in DIY"
Deutsche version vom "DIRTY emergany SD Card reader in DIY"
By UncleSashHelp for every rev 1.x USER, who is sick about the crapy SD reader.
Use this DIRTY Fix to use almost EVRY SD Card up to 32GB!
test by myself (UncleSash) and some Users in Germany!
By UncleSashThis helps you for Troubleshoot you LiBUSB Driver.
Not needed when you use teh Zidag Driver from GitHub, that comes with the latetst Version of Pin2DMD.
But also very usefull for the PinDMD2 (I had that Problem berfore with PinDMD2 and nobody, also Russ, was able to help me!)
By UncleSashSmall Help for easy troubleshooting from Basic functions, like LEDs, DeviceMode, etc.
By UncleSashTest and Format your SD Card for use in the Pin2DMD Shield
By UncleSashPin2DMD Firmware Upload (for FW Update/Upgrade or 1st use)
Pin2DMD Driver Installation (Windows)
By UncleSash1st run with the Firmware on STm32F4 with or without DotMatrixDisplay (DMD)
By UncleSashHow to connect the Pin2DMD Hardware
- 5V Power Supply
- EXTernal 5V DC for the Shield
Sorry for the Big File, there are a lot of pictures inside!
You need more Information in that File / I miss something?
Contact me via PM!